2-02 Model
Y-Case Humidity and Temperature Tranducer RS485 uses RS485 interface to transfer data. This wired interface allows to connect consistently up to 30 probes using a single cable line. The transducer is connected to RS485 by 5 wired scheme. For networking it uses FTP 5e cables. RS485 connection is carried out by sealed thread M12 connector with internal terminal block (no soldering). It's able to dismount the transducer easily, when it requires verification or calibration.
The transducer has SHT31 built-in sensor of temperature and humidity, that is remoted out of the enclosure to avoid heat impact coming from the motherboard.
The transducer consists a free hex fitting М20х1,5 / G1/2 and a copper washer.
Technical specifications of transducer
| Number of channels | 2 |
| Available channel configuration | External humidity and temperature sensor |
| Output signal | RS485, T-bus or Modbus RTU Protocols |
| Indication | OLED 0.96’ display |
| Connector | М12FA / M12FD |
| Operating Temperature, °С | -30…60 |
Technical specifications of external humidity and temperature sensor
| Sensor Curve | SHT31 |
| Process temperature range, °С | -30…60 |
| Process humidity range, % | 0...100 (at temperature 0...60 °C) |
| Sheath material | Steel 321, polyamide |
| Process connection size | М20 х 1,5 або G1/2 |
| Length of the immersion part, mm | 100, 120, 160, 200, 250 |
| Length of the remote part, mm | 70, 120 |
| Diameter of the immersion part, mm | Ø6 to Ø12 transition |
It uses high-contrast OLED display, that shows measurements receiving from all the channels, displays the serial number and RS485 net settings.
СР-06 Junction box
The transducer goes with junction box CP-06 and its power supply. Transducer’s power supply is set up inside of CP-06, as well as the terminal block for easy arrangement of RS485 input and output cables.
Technical specifications of СР-06 junction box
| Input power supply | 12-24 V DC |
| Output power supply | 5 V DC |