Y-Case Wired Humidity & Temperature Transducers w/ RS485 Output and М12 Connector
Note: to go to the page of a certain model of a probe, point the cursor on an image and click it.
Y-Case Humidity and Temperature Tranducers RS485 use RS485 interface to transfer data. This wired interface allows to connect consistently up to 30 probes using a single cable line. The transducer is connected to RS485 by 5 wired scheme. For networking it uses FTP 5e cables. RS485 connection is carried out by sealed thread M12 connector with internal terminal block (no soldering). It's able to dismount the transducer easily, when it requires verification or calibration. The transducer goes with junction box CP-06 and its power supply. Transducer’s power supply is set up inside of CP-06, as well as the terminal block for easy arrangement of RS485 input and output cables.
It uses high-contrast OLED display, that shows measurements receiving from all the channels, displays the serial number and RS485 net settings. The transducer can have several sensors depending on a model. Humidity and temperature built-in SHT31 sensor is placed inside of transducer’s case (2-16 and 2-17 models). In addition, it’s available to connect external analogue Pt1000 temperature probe with a sealed thread M8 connector for 2-17 model, and two external temperature probes via non-sealed thread M5 connectors for 2-16 model. 2-16 and 2-17 models go with magnets and mounting boards with screws to mount it easily on the vertical surface.