Y-Case Wireless Temperature Transducers w/ ZigBee 868MHz
Note: to go to the page of a certain model of a probe, point the cursor on an image and click it.
Y-Case Wireless Temperature Transducers ZigBee 868 use ZigBee interface with frequency 868 MHz to transfer data. The transducer operates by the following sequence: turning on, measuring, data transferring, turning off. In other words, the frequent measuring make quicker the batteries out. Transducer operation require an Data Logger CS10600 and a wireless Net Coordinator Y6.05-K-868.
The transducer uses high contrast OLED display for indication. It displays measurements for each measuring channel. In addition, it’s able to display radio signal level, battery charge, serial number and network settings. The transducer can go with a magnetic holder and a mounting board, that may be attached with screws.
The transducer may have one, two or three temperature sensors depending on a model. A temperature sensor TMP116 is set up inside of transducer’s case. In addition, depending on a model, the transducer can be connected by one or two external temperature analogue probes with Pt1000, either one type K probe with a cable and M5/M8/M12 connector.